Author Topic: Open Source Laser Tag project - LTAscetic  (Read 25428 times)

Pingvin

  • Developer
  • Veteran
  • ***
  • Posts: 418
    • View Profile
Re: Open Source Laser Tag project - LTAscetic
« Reply #105 on: May 24, 2015, 11:24:49 AM »



Theuer

  • Full Member
  • **
  • Posts: 61
    • View Profile
    • Email
Re: Open Source Laser Tag project - LTAscetic
« Reply #106 on: May 25, 2015, 01:12:21 PM »
  Hi c0m4r.
 I started this project in 2009. I have always tried as much as possible reality using solenoid to add a little recoil in the gun, and vibration or muscle stimulation for gunshot feedback.
 Because I used the MicroMT(not open source code)firmware, I didn't have access to pin configuration. So, I used "Status Led" out pin to activate the gun recoil system.  :P

  Recoil module is simple, consists of an optocoupler (to isolate PIC chip), connected to a TIP122 to drive a solenoid 12V.
 Here is a simple little test to illustrate.

 https://youtu.be/YD-qo7HKBFU

 See you.  :D

Pingvin

  • Developer
  • Veteran
  • ***
  • Posts: 418
    • View Profile
Re: Open Source Laser Tag project - LTAscetic
« Reply #107 on: July 17, 2017, 05:13:20 AM »
The system of the armored unit "Shield" on the basis of the printed circuit board "ascetic 3.1"


https://vk.com/lazertag_club?z=video351377583_456239059%2F055e9e86864ee8143b%2Fpl_wall_-139675220









« Last Edit: July 17, 2017, 10:12:35 AM by Pingvin »